tina60e1-a (2011-04) 43
If after programming of the hysteresis the corresponding
button <SP1> or <SP2> is pushed, the factory setting of
the corresponding hysteresis (10%) is reactivated.
Programming setpoint SP1
Programmable parameters:
(→ [3], [4], [5])
Low Trip Point
Low Trip Enable
Low Trip Point Hysteresis
High Trip Point
High Trip Enable
High Trip Point Hysteresis
Setpoint Mode
Adjusting setpoint SP2
The adjustment procedure is the same as for setpoint SP1.
To Next Page
Loading...
