6 tinb07e1-e 2011-07 Vacuum Gauge Controller
1.4.4 Disconnecting device
The Vacuum Gauge Controller is equipped with a discon-
necting device according to EN 61010-1.
The disconnecting device is located at the back of the
Vacuum Gauge Controller. See Fig. 1-3, 6.
The disconnecting device must be readily identifiable and
easily reached by the user.
In order to disconnect the Vacuum Gauge Controller from
mains, you must unplug the mains cable.
Fig. 1-3 Back side of the VGC403
A Disconnecting device
WARNING
Improper installation and operation data.
Improper installation and operation data may
damage the Vacuum Gauge Controller.
Strictly adhere to the stipulated installation
and operation data.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
