InfiNet Wireless R5000 Technical User Manual
Copyright © 2004-2006 by InfiNet Wireless Limited.
44
RMA usage
The following procedure is recommended for RMA protocol configuration:
• Define which of the network components act as a BS and which are CPEs
• Configure all CPEs on the BS using “rma ab” command
• Configure BS on each CPE using “rma bs” command
• Run RMA on each device using “rma start” command. RMA mode can
be disabled using “rma stop” command
• Enable polling mode on the BS
• Define which links are not stable at the configured speeds and try using
autobitrate mode either for some specific CPEs or for the whole cell
To Next Page
