InfiNet Wireless R5000 Technical User Manual
Copyright © 2004-2006 by InfiNet Wireless Limited.
58
RMA protocol manipulations:
• Starting/stopping the protocol
• Turning on/off the autobitrate mechanism
• Turning on/off the polling mechaism
Parameters are usually united in groups with one common “Update”
button at the bottom of the group (e.g. “RMA settings”). Unless the
button is not pressed all changes in the group does not have power.
Interfaces
Among all interfaces parameters that can be adjusted in this tabsheet, the most
important are radiointerface parameters:
• Working frequency. Usually this parameter is relevant only for BS. For
the CPE the frequency (or a list of frequencies) is set in RMA protocol
configuration and determines the list of frequencies where the BS should
be searched.
• The bit transfer rate (in Kbit/s) of the radio link.
• Power of a transmitter (in milliwatts). The values of acceptable trasmit
power levels can vary depending on the type of radio module installed.
The full list of acceptable trasmit power levels is available by using "rf if-
name capabilitites" command. If the value entered is invalid the system
will automatically set a minimal adjacent value.
• System identifier of the router, a hexadecimal number in the range of 1H
to FFFFFFH
• Distance. this parameter is used as an alternative method of link range
configuring in order to set the exact distance value between two devices
(in kilometers
There are several ways to manage this parameter:
To Next Page
Loading...
