Infoblox TE-2210 User Manual

Cabling the Appliance to a Network
For the Infoblox 2200 Series Platforms 23
1. (Applies only to Trinzic TE-2210 and TE-2220 appliances) To ensure that VRRP (Virtual Router Redundancy
Protocol) works properly, configure the following settings at the port level for all the connecting switch ports
(HA, LAN1, and LAN2):
— Spanning Tree Protocol: Disable. For vendor specific information, search for “HA” in the Infoblox
Knowledge Base system at http://www.infoblox.com/en/support/support-center-login.html
— Trunking: Disable
— EtherChannel: Disable
— IGMP Snooping: Disable
— Port Channeling: Disable
— Speed and Duplex settings: Match these settings on both the Infoblox appliance and switch
— Disable other dynamic and proprietary protocols that might interrupt the forwarding of packets
Use the Grid Manager from a management system to access, set up and administer the Infoblox appliance. For
management system requirements and access instructions, see Accessing the Infoblox 2200 Series Appliance on
page 25.

Infoblox TE-2210 Specifications

General

Brand	Infoblox
Model	TE-2210
Category	Network Hardware
Language	English