Infoblox 2200 Series Field Replaceable Units
34 Infoblox Installation Guide
Figure 15 RAID 10 Array Configuration
Evaluating the Status of the Disk Subsystem
You can monitor the disk subsystem through the Grid Manager, the scrolling front panel LCD display, and the front
panel LEDs for the disk drives. You can also view disk status by using the CLI command show hardware_status.
To see a detailed status report, log in to the Grid Manager and from the Grid -> Grid Manager tab, select the
appliance, and then click the Detailed Status icon. (For more information on the Detailed Status panel, refer to the
Infoblox Administrator Guide.)
The color of the RAID icon indicates the status of the RAID array on Infoblox 2200 Series appliances.
The Grid Manager also displays detailed status of the RAID array. In the event of a disk failure, you must replace the
failed disk with one that is qualified and shipped from Infoblox and has the same disk type as the rest of the disks
in the array. The appliance displays information about mismatched disks in the Detailed Status panel.
Note that all disk drives in the array must have the same disk type (IB-Type 5) for the array to function properly.
When you have a mismatched disk in the array, promptly replace the disk with a replacement disk from Infoblox to
avoid operational issues.
Note: For replacement disk assembly part numbers, see Table 4 on page 41.
Color Meaning
Green The RAID array is in an optimal state.
Yellow A new disk was inserted and the RAID array is rebuilding.
Red The RAID array is degraded. At least one disk is not functioning properly. The Grid Manager lists the disks
that are online. Replace only the disks that are offline.
To Next Page
Loading...
Need help?
General
