Infoblox 2200 Series Rack Mounting Procedures
For the Infoblox 2200 Series Platforms 19
Figure 8 Chassis Slide Rail and Rack Slide Bracket
4. Align the mounting holes on the chassis slide rails with the rear-most mounting holes on each side of the
chassis. Ensure that you place the chassis slide rails in the correct orientation. Otherwise, the mounting holes
do not align properly.
5. Attach the chassis slide rails to each side of the chassis with two (2) 8-32 screws, as shown in Figure 9.
Figure 9 Chassis Slide Rail alignment with chassis (Four-Post mount)
6. Select a desired location and secure the rack slide brackets to the rear posts of the equipment rack with two
(2) 10-32 screws on each side of the rack.
7. With one person on each side, lift the appliance and position it in front of the equipment rack.
8. Align the chassis slider rails on the appliance with the rack slide brackets on the posts of the equipment rack.
9. Slide the appliance into the rack slide brackets.
10. Secure the rack ears to the front rack posts with two (2) 10-32 screws on each side of the rack.
Adjustable Rail Four-Post Rack Mounting
Infoblox provides an adjustable four-post rail kit with 600mm to 900mm depth adjustment, designed to allow one
person to perform physical installation of the rack kit and the appliance. This kit is provided as a field-replaceable
unit; for information, see
Replaceable Unit and SFP Part Numbers in this Guide. The adjustable rail kit is designed
to allow one person to perform the physical installation of the rail kit and the appliance.
To Next Page
Loading...
Need help?
General
