Installing and Cleaning the Dust
Filter
Dust lters are
only required/sup-
plied in selected
regions with ex-
cessive dust.
Installing the Dust Filter
Procedure:
Install two lters.1.
Turn on the projector then press “Menu”, go to “OPTIONS -> Op-2.
tional Filter Settings -> Optional Filter Installed” and select “Yes”.
Cleaning the Dust Filter
We recommends cleaning the dust lter every three
months; clean it more often if the projector is used in a
dusty environment.
Procedure:
Switch off the power to the projector by pressing the “1. ” button.
Disconnect the power cord.2.
Remove the dust lter slowly and carefully.3.
Clean or replace the dust lter.4.
To install the dust lter, reverse the previous steps.5.
Reset the dust lter counter after replacing or cleaning the dust 6.
lter. Press “Menu”, go to “OPTIONS -> Optional Filter Settings ->
Filter Reset”
Turn on the projector, then press “Menu”, “OPTIONS -> Optional
Filter Settings -> Optional Filter Installed” and select “No” when
you pull out the dust lter and would not install it again.
To Next Page
Loading...
