9
8
www.infopia21.com
GLUCOLAB
TM
Auto-coding Blood Glucose Monitoring
System KIT Contents
Your GLUCOLAB
TM
Auto-coding Blood Glucose Monitoring System has
been sealed and should contain all of the parts shown above. Please
return the system to the place of purchase or contact your nearest GLU-
COLAB
TM
Auto-coding representative if the container seals are broken or
parts are missing.
1.
GLUCOLAB
TM
Auto-coding Blood
Glucose Test Meter
2.
GLUCOLAB
TM
Auto-coding Blood
Glucose Test Strips
3.
Lancing Device
4.
Lancets
5. Operation
Manual
6. Warranty Registration Card
7. Patient Logbook
8. Carrying Case
9. Two 3V Li-CR2032 Batteries
10. Control Solution Normal
GLUCOLAB
TM
Auto-coding Blood Glucose Test Meter
INFM22A
BLOOD GLUCOSE TEST METER
BLOOD GLUCOSE TEST METER
For use with Blood Glucose Test Strip only
GL-5C13-1C0-03 Rev.2009-04
GL-5C13-1C1-03 Rev.2009-04
Bd. General Wahis 53
1030 Brussels, Belgium
Blood glucose test strip Port:
Insert the GLUCOLAB
TM
Auto-
coding blood glucose test strip
here.
Blood glucose test strip ejector
Display Screen:
Displays your test results, sym-
bols and messages.
Function Button:
Powers the meter on/off, prompts
memory data and acts as an
enter button during setup and
after tests.
Up/Down Arrow Buttons:
Adjusts setting, scrolls through
memory
Serial Number
Battery Cover
CAUTION
1. Do not use GLUCOLAB
TM
Auto-coding blood glucose test meter in a dry
environment, especially if synthetic materials are present. Synthetic
clothes, carpets, etc., may cause damaging static discharges in a dry envi-
ronment.
2. Do not use GLUCOLAB
TM
Auto-coding blood glucose test meter near cellu-
lar or cordless telephones, walkie talkies, garage door openers, radio
transmitters, or other electrical or electrical equipment that are sources of
electromagnetic radiation, as these may interfere with the proper operation
of the blood glucose test meter.
To Next Page
Loading...
