Infortrend EonNAS Pro Series - Page 42

EonNAS Pro Series Hardware Manual
Once you are
in the “Gateway Local host” screen, you can configure detail gateway
settings (settings can also be configured using the web interface, please refer to the
Web Interface Manual).
SELEC T
ENTER
TCP / IP
Gateway
SELEC T
ENTER
Gateway - 0
Local host
SELEC T
ENTER
Destination
Local host
SELEC T
ENTER
Netmask
[IP address]
SELEC T
ENTER
Gateway
Local host
SELEC T
ENTER
Config
Delete gateway
SELEC T
ENTER
[Go back]
SELECT
ENTER
G
ateway
A
dd new gateway
SELECT
ENTER
S
et destination
00.000.000.0000
SELECT
ENTER
S
et netmask
2
55.255.255.000
SELECT
ENTER
S
et gateway
0
0.000.000.0000
SELECT
ENTER
A
re you sure?
->Yes No
SELECT
ENTER
G
ateway
[
Go back]
SELECT
ENTER
Press the “ENTER” button to enter the sub-menu (Set Destination) from the screen
“Gateway - Add New Gateway” and you will see an underline cursor (eg.
0
00.000.000.000). To configure the destination IP address, press the “SELECT” button
with the underline cursor beneath the number you wish to modify. By pressing the
“SELECT” button, the digit will change incrementally. Once you have set the desired
number, press the “ENTER” button and the cursor will move onto the next digit (eg.
00
0.000.000.000). The rest of the IP addresses are configured likewise.
42