Infortrend EonNAS Pro Series - Page 43

EonNAS Pro Series Hardware Manual
If a Gateway has been
setup, an “IP address (xxx.xxx.xxx.xxx)” will appear in the
menus. Once you are in the “Gateway-1 [IP address]” screen, you can change the
gateway settings (settings can also be configured using the web interface, please refer
to the Web-Interface Manual).
SELECT
ENTER
TCP / IP
Gateway
SELECT
ENTER
Gateway - 1
[IP Address]
SELECT
ENTER
Destination
[IP address]
SELECT
ENTER
Mask
[IP address]
SELECT
ENTER
Gateway
Local host
SELECT
ENTER
Delete Gateway
SELECT
ENTER
[Go back]
SELECT
ENTER
G
ateway
Add new gateway
SELECT
ENTER
S
et gateway
0
0.000.000.0000
SELECT
ENTER
Are you sure?
->Yes No
SELECT
ENTER
G
ateway
[
Go back]
SELECT
ENTER
S
et destination
00.000.000.0000
SELECT
ENTER
S
et netmask
2
55.255.255.000
SELECT
ENTER
To configure the destination IP address, please refer to the previous page for
instructions.
43