112
Replacing Flash Backup Module (coupled with SuperCap)
Up to two flash backup modules can be installed. If there are two host boards
installed, to gain access to the FBMs will require the user to remove the second host
board. Once the second host board has been removed, please read the following
instructions to replace the flash backup module:
1. Remove the controller module (refer to Replacing the Controller Module).
2. Loosen the screw at the end of flash backup module and remove the flash
backup module.
3. Insert the replacement flash backup module on a 45 degree angle, gently lower
the other end of the SSD and secure it with the original screw.
To Next Page
Loading...
