Infortrend EonStor GS 3000 Series - Power On Status Check

83
NOTE
Make sure all power supply modules’ switches are turned on!
Power On Status Check
As a general rule, once the system has been powered on, there should NOT be
LED(s) that light up red / amber nor should you hear an audible alarm from the
system. You may verifying system statuses via the following monitoring interfaces:
 LEDs on rear chassis, including controller module, PSUs, and cooling
modules (refer to System Monitoring).
Controller LEDs:
1.
Ctrl Status LED: On (green)
3.
C_Dirty LED: Off
2.
CBM Status LED: On (green)
or Off (if not installed)
4.
Hst Bsy LED: On (green)
PSU & Cooling Module LEDs:
PSU LED: On (green)
Green