23
Controllers (1) / (2): Each RAID controller module contains a main
circuit board and a pre-installed DIMM module. For Single-Controllers, a
dummy cage will be placed at the controller (2) position. The host port
configurations will vary. For details, see Rear Panel Components.
PSU (3): The hot-swappable PSUs provide power to the system.
There is a cooling module within each PSU. Please refer to your specific
system for details shown in the later sections of this chapter.
WARNING
Do NOT remove the dummy cage for the Single-Controller model. Doing so will
disrupt the internal airflow.
To Next Page
Loading...
