Infranor XtrapulsPac Installation Guide

17
Chapter 3 – Inputs-Outputs
XtrapulsPac Installation Guide
Mounting instructions:
- Clean the contact surface of the heatsink with alcohol.
- Apply a thermal interface between the drive plate and the heatsink. Recommended thermal interfaces:
o A thin layer of thermal paste on the drive (recommended reference: RHODORSIL Paste 340).
o Phase change thermal interface (recommended reference: Bergquist, Hi-Flow 225F-AC,
15050 mm)
- Fasten the drive with 4 screws and tooth lock washers.

Infranor XtrapulsPac Specifications

General

Brand	Infranor
Model	XtrapulsPac
Category	Controller
Language	English