Intégration Guide_iUC150&iUC180 60/70 Copyright © 2012 Ingenico
900009816 R11 000 01/1223 All rights reserved
6.4 INSTALLING THE IUC150/IUC180 IN NEW KIOSK
iUC150/iUC180 requires standards hexagonal nuts for integration into a kiosk.
Screw the 4 nuts M4 with a 1.0 N.m torque.
It is recommended to use washers.
Picture showing a new installation of the iUC180 or iUC150
Installation of the iUC180 or iUC150 with 6 studs position
Mounting with 6 studs is possible.
The two middle studs will not be
screwed.
For connectors access, limit the stud
length at Lmax = 11.5mm on both back
studs
L max of the 2 back
studs
To Next Page
Loading...
