Ingenico iUC150 - Maintenance; 7.1 Configuration; 7.2 Operating Life

Intégration Guide_iUC150&iUC180 62/70 Copyright © 2012 Ingenico
900009816 R11 000 01/1223 All rights reserved
7 MAINTENANCE
7.1 CONFIGURATION
The iUC180 & iUC150 supplied to you has operational configuration loaded.
In factory, software is loaded in the iUC180 & iUC150, as well as parameter definition
files.
For iUC180:
The parameter definition file of the UCMC component is used, in particular, to
determine the type of printer used (local/host) and the position of the host (COMx).
To change configuration, you must load a new parameter definition file (supplied by
Ingenico).
This operation can be performed using the LLT or a USB key (see § Loading by USB
key)
For more information concerning configuration, contact Ingenico Technical Support.
7.2 OPERATING LIFE
Minimum operating life of 5 years.
8 CLEANING INSTRUCTIONS
The external front face of the contactless reader should be carefully cleaned on a
regular basis.
First of all, unplug all the wires from the terminal during this operation.
Good rules for proper cleaning of the terminal are:
• Use a soft cloth that is very slightly soaked with soapy water to clean the
outside of the terminal.
• The glass has special surface treatment but must be carefully clean.
• Do not clean the electrical connections.
• Do not use in any case, solvents, detergents or abrasive products:
Those materials might damage the plastic or electrical contacts.
• Avoid also the use of pressurized liquids.
• Avoid exposing the terminal to the direct rays of the sun.