32 Installation
Anti-intrusion control panels
Note
If you exit the Installer menu before replacing the panel frontplate, the system panel will not generate
an “Open-panel” event.
However, the system will generate an open-panel event, if the frontplate is not replaced within 15
seconds of closing the open-tamper microswitch.
3-1-6
Land-line connection (PSTN)
Connect the land line (PSTN) to terminals 39 and 40 on the control panel motherboard (Table
2-7: Mother board - terminal board, 39-40).
If you are installing the system in a place where the land line (PSTN) service is not available,
or if you wish to increase the level of security of the system, these terminals also accept a
GSM interface (such as SmartLinkAdv) which simulates the analogue land-line.
Inim's SmartLinkAdv telephone dialler is available in two versions, model G and model GP.
Both devices monitor the analogue land line and in the event line-down conditions (e.g. wire-
cutting) simulate the analogue land line and allow the control panel to switch incoming/
outgoing calls to the GSM network.
You can also use the terminals on the SmartLinkAdv board to extend the functions provided
by the Prime system. The following section describes several methods which will allow you to
provide users with advanced functions.
• Arming/Disarming the system over-the-phone using a cost-free call or SMS text
By connecting one of the Prime board terminals programmed as “follow zone” to an output
on the SmartLinkAdv board, it will be possible to arm or disarm the Prime system via SMS
text.
In a similar way, using a terminal programmed as a “switching zone”, it will be possible to
arm or disarm the control panel simply by means of a recognized incoming call.
• Receive an SMS text in the event of Control panel alarm
By connecting one of the alarm outputs of the Prime control panel to an input on the
SmartLinkAdv board, it will be possible to receive alarm communications via SMS text. The
system can be set up to send an SMS text (editable) to 10 different contact numbers.
All the functions of the Prime system which use the PSTN line (voice dialer, answerphone,
alarm receiving centre and teleservice) can be managed completely over the GSM network by
the SmartLinkAdv. This device also allows teleservice maintenance over the GSM network.
Note
If there are ADSL filters on the line, you must connect the control panel downstream of the filters, to the
line dedicated to telephone equipment (this line is clearly indicated on the filters).
If the control panel is not equipped with a SmartLogos30M voice board, voice calls will
produce a continuous beep for 30 seconds.
3-1-7
Connecting to a PC
In order to program the control panel using a PC, it is necessary to have the Prime/STUDIO
software (refer to the programming manual) and a USB cable with a microUSB terminal or an
Ethernet cable.
To connect the PC, simply insert the cable into the appropriate connector (Table 2-6: Mother
board - description of parts, L for an Ethernet cable or Table 2-6: Mother board - description
of parts, N for a USB cable.
For details regarding the connection, refer to the Prime/STUDIO software manual.
3-1-8
Connecting the SmartLogos30M board
For proper installation of the board, work carefully through the following steps.
1. Disconnect all power sources to the control panel (mains and lead batteries).
2. Connect the board to the appropriate connector (Table 2-6: Mother board - description
of parts, C).
3. Power up the system from the mains and reconnect the lead batteries.
Smart
LinkAdv
Control
To Next Page
Loading...
