Inmes IC-1000 ELECTRONIC - Adhesive Loading Procedure

INMES Industrial ltda – COLADEIRA DE BORDA IC-1000 ELECTRONIC
12
Fig. 22
Fig. 23
6.3 – Placing the adhesive into the glut pot
 Remove the cover from the glue pot. 24.
 Place approximately 500g (17oz) of adhesive fig. 25. Use only adhesives for low to middle speed
edgebanders.
Fig. 24
Fig. 25
 Never put your hands or other body parts inside the glue pot, as this presents risks of severe burning.
 Never mix adhesives with different formulations, this will decrease the efficiency of your edgebander.
Always clean the glue pot when replacing the adhesives.