Inmes IC-1000 ELECTRONIC - Thick Edgeband Adjustments

To Next Page

To Previous Page

INMES Industrial ltda – COLADEIRA DE BORDA IC-1000 ELECTRONIC

6.8 – Machine adjustments for edgeband thicker than 0,5mm (1/64”) and maximum 3,00mm

(1/8”)

To work with edgebands thicker than 0,5mm (1/64”) and maximum 3,00mm (1/8”), follow the pro-

cedures below:

 With a 5mm Allen Key, loosen the indicated bolts, as shown in fig. 37.

Fig. 37

 It is recommended to use a 100mm (3 15/16”) long and 15mm (19/32”) wide MDF board (not sup-

plied with the machine) and use a 500mm long (19 11/16”) edgeband with the desired thickness (not

supplied with the machine) for the adjustment, as shown in fig. 38.

Fig. 38

 Perform the edge banding on the MDF board, per 39.

Fig. 39