Inmes IC-1000 ELECTRONIC - Unpacking Procedure

To Next Page

To Previous Page

INMES Industrial ltda – COLADEIRA DE BORDA IC-1000 ELECTRONIC

2 – RECEIVING THE IC-1000 ELECTRONIC EDGEBANDER

2.1 – Removing the machine from the crate

The IC-1000 ELECTRONIC edgebander is shipped from the factory inside a wood crate, per fig. 02.

 Using a hammer (does not come with the machine), open the wood crate, with caution, as nails and

wedges may injure the operator.

Fig.02

Fig.03

Fig.04

Check to make sure all following items are included:

01 unit - IC-1000 ELECTRONIC edgebander;

01 User manual;

01 unit - Edgeband support (fig. 03);

01 Cutting assembly (fig. 04);

02 B

lades (fig. 04);

01 5,0mm Allen key (fig. 04);

01 6,0mm Allen key (fig. 04);

01 10x11mm fixed wrench (fig. 04);

04 Levelers (fig. 04).

 Due to its weight, it is recommended the use of a pallet jack type device fig. 01 page 05.

 Always work with the machine over a flat and solid surface.

 If any of the previously mentioned items are missing,

please contact us immediately: INMES INDUSTRIAL LTDA –

export@inmes.com.br – or contact your local dealer.

 Do not connect the machine to the

electrical grid before removing it

from the wood crate.