INMES Industrial ltda – COLADEIRA DE BORDA IC-1000 ELECTRONIC
When turning the machine off, wait for at least 5 seconds to turn it on again.
6.6 – Feed rate adjustment
To adjust the feed rate, proceed in the following way:
Turn the button beside the display, per Fig.33. Turning it clockwise, the speed increases and turning it
anticlockwise, the speed reduces.
The edgebander works within a speed range of 3,5m/min. up to 9m/min. (11 to 29 feet/minute).
Obs: This command will work only when the forward button is positioned in “ON” and the roller is
spinning.
6.7 – Gluing the edgeband
It is recommended that the pieces to be glued are dry and free of dust and oils. For wood veneers,
ideally, they must be free of moisture and stored in a kiln prior to edgebanding. For wood substrates, the mois-
ture must be preferably between 8-12%. The edgebanding can be affected by the room temperature, for both
the adhesive and the materials to be processed. Therefore, the minimum room temperature for working must
be 18 °C (64 °F).
Never adjust the amount of glue until it reaches the work temperature.
The room temperature affects the adherence of the edgeband. It is recommended a pre-heating of
the edgeband when the room temperature is lower than 18ºC (64 ºF) for a superior edgebanding
result.
In cold weather, it is recommended to turn the machine on 30 minutes prior to start working.
To Next Page
Loading...