Inmes IC-1000 ELECTRONIC - Common Problems & Solutions

INMES Industrial ltda – COLADEIRA DE BORDA IC-1000 ELECTRONIC
24
 It is recommended that the pieces to be edgebanded are dry and free of dust and oils. For wood ve-
neers, they must be ideally free of moisture and stored in a kiln prior to be bonded. For wood sub-
strates, the moisture must be between 8-12% preferably.
8 – TROUBLESHOOTING
 Turn the machine off using the general button and unplug it from the electrical power before performing
any maintenance.
Problem
Likely Causes
Solu
tions
Machine will not turn on
Power cable disconnected
Connect the power cable
On/Of
f button
damaged
Contact
INMES
customer service
Motor is burned
Contact INMES customer service
Emergency button is activated
Disactivate the emergency button
Adhesive will not reach its
temperature
Resistance is burned
Contact specialized
electrician
Thermocouple is burned
Contact specialized electrician
Temperature controller is damaged
Contact INMES customer service
Edgeband will not bond to
the piece
Not enough adhesive
Put more adhesive in the machine
Low adhesive temperature
Check if the temperature of the
controller is correct
. P
a
g
e
14.
Piece not squared
Check if the base of the piece and the
side to be edgebanded are square (90º
angle
). P
a
g
e 1
6.
Blade will not cut the
edgeband
Cutting blade is dull Replace the cutting blade
Motor will not start
Motor is burned
Contact INMES customer service
Issue with frequency inverter
Check table below
Glue pot has not reached the ideal
temperature
Wait until the ideal temperature is
reached
.
Not enough adhesive in large
pieces
Adhesive thickness adjustment is too
open. Excess of adhesive
.
Reduce the amount of adhesive.
Check item
6.5. Pg. 15.