Inner Range 996300NAPS - Wiring Diagrams; Power Supply; Output Relays (OUT1 - 4)

Inner Range Inception Security Controller Installation Manual. Rev. 6.0
© 2016 - 2023. Inner Range Pty Ltd.
12 www.innerrange.com
WIRING DIAGRAMS
Power Supply
OPTION 1.
Supplied 24V PSU and Battery.
Check for correct polarity when
installing the supplied battery wires.
“BATT +” terminal to Battery +.
“BATT –“ terminal to Battery -.
OPTION 2.
Integriti 3A/8A PSU
or third party battery-backed
power supply.
Output Relays (OUT1 – 4)
Lock or Solenoid Control. An External Power Supply is recommended to power inductive loads to
protect the controller, provide longer battery backup & minimise the possibility of earth loops.
Non-Inductive Loads. e.g. 12V Sounder, Beeper, Strobe, LED, etc. The Inception power supply may
be used to power these devices. Check that the additional current required by these devices does not
cause the Inception power supply output limits to be exceeded.
The clamp diode
supplied in the
accessory kit must
be fitted across
inductive loads (e.g.
door lock). Cathode
(bar) to +ve.
“DC IN” not
connected.