Inovance IS300T080-C - 2.7 Routine Repair and Maintenance

Chapter4FunctionCodeTable

25
Function
Code
Parameter Name Setting Range Min. Unit Default Property
(Err23)
24-25: Reserved
26: Running time reached
27: Business running
time reached
28-41: Reserved
42: CAN communication
interrupted (Err42)
43: Encoder fault during
motor auto-tuning (Err43)
44: Speed deviation too
large (Err44)
45: Motor overheat
(Err45)
46: Pressure sensor fault
(Err46)
47-48: Multi-pump
parallel run fault (Err47,
Err48)
49: Encoder signal fault
(Err49)
52: Multi-master fault in
multi-pump convergent
flow( Err52)
58: Parameter restoration
fault (Err58)
F9-21 Frequency upon fault - 0.01 Hz - 
F9-22 Current upon fault - 0.1 A - 
F9-23 Bus voltage upon fault - 0.1 V - 
F9-24
Input terminal state
upon fault
- 1 - 
F9-25
Output terminal state
upon fault
- 1 - 
Group FP: User Password and Parameter Initialization
FP-00 User password 0–65535 1 0
☆
FP-01 Restore default settings
0–2
0: No operation
1: Restore default
settings
2: Clear fault records
1 0
☆
FP-02 Motor model code 0–65535 1
Model
dependent
☆