- 98 -
It is applicable to the applications where the load requirements are rather low
or one driver drives multiple motors, such as fan and pump loads. It can be
used in the applications where one driver drives multiple motors.
Prompt: Motor parameter identification must be conducted when selecting
the vector control mode. Only when correct motor parameters are provided
can the vector control mode be fully made use of. Better performance can
be achieved by adjusting the speed regulator parameters (group F2).
Command Source
Selection
Factory default
value
0
0 Operation panel command
1 Terminal command channel
F0-02
Setup
Range
2
Serial port communication
command channel
Select the channel for driver control command.
The driver control command includes start, stop, forward rotation, reverse
rotation and Jog.
0: Operation panel command channel (“LOCAL/REMOT” LED OFF);
Perform running command control with keys on the operation panel, such as
RUN, STOP/RES keys.
1: terminal command channel (“LOCAL/REMOT” LED ON)
Perform running command control by the multifunctional input terminals such
as FWD, REV, JOGF, JOGR, etc.
2: serial port command channel (“LOCAL/REMOT” LED flashes)
The running command is sent by the host computer via the communication
mode.
Main frequency source X
selection
Factory default
value
0
0
Digital setup UP and DOWN
(non-recorded)
1
Digital setup UP and DOWN
(non-recorded)
2 AI1
3 AI2
4 AI3
5 PULSE setup (Dl5)
6 MS speed
F0-03
Setup
Range
7 PLC
To Next Page
Loading...
