- 55 -
Chapter 5 Function Parameter Table
If FP-00 is set to non-zero value, it means parameter protection password is
set, and the parameter menu cannot be entered until correct password is input.
To cancel the password, it needs to set FP-00 to “0”.
The parameters in the shortcut menu are free from password protection.
The symbols in the function table are described as follows:
It indicates that the parameter setup value can be modified when the driver is
in stop status and running status.
It indicates that the parameter setup value cannot be modified when the driver
is in the running status.
It indicates that the numerical value of the parameter is the actually measured
value, which cannot be modified.
“*”: It indicates this parameter is “Factory default parameter” and can be set
only by the manufacturer.
To Next Page
Loading...
