- 7 -
1.2.10 Certain Special Use
If the user needs to use the driver with the methods other than the
recommended wiring diagram in this manual, such as shared DC bus, please
consult our company.
1.2.11 Precaution of Driver Disposal
The electrolytic capacitors on the main circuit and the PCB may explode when
they are burnt. Emission of toxic gas may be generated when the plastic
parts are burnt. Please dispose the servo driver as industrial wastes.
1.2.12 Adaptable Motor
1) The standard adaptable Permanent-Magnet Synchronous Motor
2) Since the servo driver has built-in standard parameters of the adaptable
motors, it is necessary to perform motor parameter identification or modify
the default values so as to comply with the actual values as much as
possible, or it may affect the running effect and protection performance;
3) The short circuit of the cable or motor may cause alarm or explosion of the
driver. Therefore, please conduct insulation and short circuit test on the
newly installed motor and cable. Such test shall also be conducted during
routine maintenance. Please note that the servo driver and the test part
shall be completely disconnected during the test.
To Next Page
Loading...
Need help?
General
