- 130 -
Setup value Function Description
frequency of the driver reaches the frequency upper
limit and frequency lower limit, it outputs ON signal.
14 Torque limiting
When the torque limiting function is enabled, the stall
protection function is automatically enabled and the
output frequency is automatically changed.
Meanwhile, it outputs ON signal, indicating that it is
outputting torque limit. This output signal can be
used to reduce load or display overload status signal
on the monitoring device.
15
Ready for
running
When the main circuit and control circuit power
supply are connected, the driver protection function
is inenabled, and the driver is in running status, it
output ON signal.
16 AI1>AI2
When the analog input AI1 value is higher than AI2
value, it outputs ON signal.
17
Frequenc-y
upper limit
arrival
When the running frequency reaches frequency
upper limit, it outputs ON signal.
18
Frequenc-y
lower limit
arrival
When the running frequency reaches frequency
lower limit, it outputs ON signal.
19
Under voltage
status output
When the driver is in under voltage status, it outputs
ON signal.
20
Communication
setup
Refer to the communication protocol for relevant
descriptions.
21～22 Reserved －
23
Double
displacement
Plunger Pump
swashplate
swicth（NO）
Double displacement Plunger Pump displacement
swicth
24
Pressure
control status
output (NC)
25
Alarm output
from pump(NC)
To Next Page
Loading...
