Inovance MD380L - Output Terminal Functions (Group F5)

29
5.6 Group F5: output terminals
Function
Code
Parameter name Setting Range
Unit
Default
Commission
F5-00 FM terminal output mode 0 : High-speed pulse output (FMP)
1 : ON/OFF output (FMR)
N.A
1
F5-01 FMR function
(open-collector
output terminal)
Attention!
Set F5-00 = 1 when FM is
used as
MC or Brake output.
0 : No output
1 : AC Drive running
2 : Fault output (stop)
3 : Frequency-level detection FDT1
output
4 : Frequency reached
5 : Zero-speed running
(no output at stop)
6 : Motor overload pre-warning
7 : AC Drive overload pre-warning
8 : Set count value reached
9 : Designated count value reached
10 : Length reached
11 : PLC cycle complete
12 : Accumulated running time reached
13 : Frequency limited
14 : Torque limited
15 : Ready for RUN
16 : AI-1 larger than AI-2
17 : Frequency upper limit reached
18 : Frequency lower limit reached
(no output at stop)
19 : Under-voltage state output
20 : Communication setting
21-22 : Reserved
23 : Zero-speed running 2
(having output at stop)
24 : Cumulative power-on time reached
25 : Frequency-level detection FDT2
output
26 : Frequency 1 reached
27 : Frequency 2 reached
28 : Current 1 reached
29 : Current 2 reached
30 : Timing reached
31 : AI-1 input limit exceeded
32 : Load becoming 0
33 : Reverse running
34 : Zero current state
35 : Module temperature reached
36 : Software current limit exceeded
37 : Frequency lower limit reached
(having output at stop)
38 : Alarm output
39 : Motor overheat warning
40 : Current running time reached
41 : Fault output
(There is no output if it is the
coast-to-stop fault and under-voltage
occurs)
42 : Brake output
43 : MC (Magnetic contactor) output
N.A
2
F5-02 Relay function
(T/A-T/BT/C)
N.A
43
F5-03 Extension card relay
function (P/A-P/B-P/C)
N.A
42
F5-04 DO-1 function selection
(open-collector output
terminal)
N.A
0
F5-05 Extension card DO-2
function
N.A
0
F5-07 AO1 function selection 0 : Running frequency
1 : Set frequency
2 : Output current
3 : Output torque (absolute value)
N.A
3