Mechanical Installation
‑25‑
Figure 1‑9 3D of the cabinet for T11 and T12 models
2. Fix the bottom mounting bracket in the nine‑fold profile cabinet.
Fix the mounting bracket to the base of the nine‑fold profile cabinet by using six M5
self‑tapping screws, as shown in "
Figure 1–10
"
on page 25
.
Figure 1‑10 Installing the bottom mounting bracket
Drill holes for the mounting bracket and assemble the bracket on site if the cabinet is not a
nine‑fold profile one.
3. Assemble the guide rails (model: MD500‑AZJ‑A3T10) and mount the guide rail as‑
sembly to the cabinet.
a. Assemble the guide rail, as shown in "
Figure 1–11
"
on page 25
.
Figure 1‑11 Assembling guide rails
b. Align the two round holes at the front end of the mounting rail with the screws
of the mounting bracket, and then lock the guide rail to the cabinet with two M6
nuts, as shown in "
Figure 1–12
"
on page 26
.
To Next Page
Loading...
