Installation
‑44‑
Screws
Table 5–6 Specifications and quantities of screws (T1 to T9 models)
Installation Method Specification
Quantity
(PCS)
Description
Backplate mounting Dependent on the
mounting hole
diameter (provided
by the user)
4
Used to fix the AC drive onto
the wall
Through‑hole
mounting
Dependent on the
mounting hole
diameter (provided
by the user)
4
Used to fix the AC drive onto
the backplate of the control
cabinet
Table 5–7 Specifications and quantities of screws (T10 to T12 models)
Installation Method Specification
Quantity
(PCS)
Description
Installation in a
cabinet
M5 self‑tapping
screw
6
Used to fix the bottom
mounting bracket to the
bottom of the cabinet
M5x12 SEMS screw 8
Used to assemble the guide
rails
M6 nut 2
Used to connect the guide
rail assembly to the bottom
mounting bracket
Tools for wiring
For wiring of main circuit terminals, use installation tools appropriate to terminal
dimensions and secure the joints well.
Table 5–8 Wiring tools for main circuit terminals
Model Recommended Fastener Tool
T1 and T2
M4 SEMS screw
Phillips screwdriver (#3 slot)
T3 and T4
M5 SEMS screw
Phillips screwdriver (#3 slot)
T5 and T6
M6 SEMS screw
Phillips screwdriver (#3 slot)
T7
M8 nut, spring washer, and flat
washer
Socket wrench (#13 socket)
T8 and T9 M12 nut, spring washer, and
flat washer
Socket wrench (#19 socket)
and socket wrench extension
bar (150 mm)
To Next Page
Loading...
