Installation
‑53‑
Ensure that there is no stress on the positive and negative bus terminals.
Figure 5‑13 Hoisting T10 to T12 models
2. Hook the sling to the hoisting lugs diagonally placed at the top of the AC drive,
slowly put the AC drive upright for installation in the cabinet.
Avoid stress on any side of the AC drive or placing it on an inclined surface. The AC drive is
large and heavy (close to 200 kg). If the inclination exceeds 5°, it may topple.
5.5.4 Unpacking
T1 to T12 models
Related documents and accessories are placed in different partitions in the crate. To
unpack, follow these steps:
1. Remove all ties and the cover of the crate.
2. Remove all packing materials.
3. Take out the AC drive.
4. Cut and remove the plastic wrap around the AC drive.
5. Check for damage.
6. Dispose of or recycle the packaging in accordance with local regulations.
To Next Page
Loading...
