Installation
‑51‑
● During transportation, keep the AC drive upright as indicated on the packaging
box, as shown in the following figure.
Figure 5‑11 Placing the AC drive
5.5.3 Transportation and Hoisting After Unpacking
T1 to T6 models are relatively small and light and therefore can be handled manually.
T7 to T12 models, however, must be transported with an appropriate hoisting tool.
Weight of AC Drive Persons Needed for Transporting
< 15 kg
1
≥ 15 kg > 2; with an appropriate hoisting device
Precautions for transporting and hoisting:
● Comply with local regulations.
● Avoid handling the AC drive by directly holding its upper access cover or
enclosure. Before moving it, check that all screws are tightened. Failure to comply
may result in fall‑off of the AC drive, causing injury.
● For T10 to T12 models, ensure that the four mounting holes on the back of the AC
drive are connected to the fixing beams.
● Erect the AC drive that is lying flat before hoisting or moving it.
● Where applicable, use a crane with a capacity greater than the weight of the AC
drive.
To Next Page
Loading...
