System structure
‑14‑
Figure 1‑2 Example wiring of a three‑phase 220 V or 380 V system
Note
CN6 (STO terminal) is only applicable to customized model ‑FS.
1.2 System Composition
● The servo drive is directly connected to an industrial power supply, with no
isolation such as a transformer. A fuse or circuit breaker therefore must be
connected to the input power supply to prevent electric shock in the servo system.
For the sake of safety, install a residual current device (RCD) to provide protections
against overload and short circuit or a specialized RCD to protect the grounding
cable.
To Next Page
Loading...
