Terminals
‑52‑
Table 3–8 Brake specifications
Motor Model
Holding
Torque
(N·m)
Supply
Voltage
(VDC)
±10%
Coil Resistance
(Ω)±7%
Exciting
Current
(A)
Release Time
(ms)
Apply Time
(ms)
Backlash
(°)
MS1H1‑05B/10B
0.32
24
94.4 0.25 ≤ 20 ≤ 40 ≤ 1.5
MS1H1‑20B/40B
MS1H4‑40B
1.5 75.79 0.32 ≤ 20 ≤ 60 ≤ 1.5
MS1H1‑75B/
MS1H4‑75B
3.2 57.6 0.42 ≤ 40 ≤ 60 ≤ 1
MS1H2‑10C/15C/
20C/25C
8 25 0.96 ≤ 30 ≤ 85 ≤ 0.5
MS1H2‑30C/40C/
50C
16 21.3 1.13 ≤ 60 ≤ 100 ≤ 0.5
MS1H3‑85B/13C/
18C
12 29.7 0.81 ≤ 60 ≤ 120 ≤ 0.5
MS1H3‑29C/44C/
55C/75C
50 14.4 1.67 ≤ 100 ≤ 200 ≤ 0.5
Note
● The brake cannot share the same power supply with other electrical devices. This
is to prevent malfunction of the brake due to voltage or current drop caused by
other working devices.
● Use cables with a cross‑sectional area above 0.5 mm
2
.
3.3 Description of Encoder Terminal (CN2)
Terminal Layout
Figure 3‑8 Encoder terminal pin layout
To Next Page
Loading...
