15
STEP 4: MAST ASSEMBLY (See STEP 4)
Required Hardware: STEP 5
2x (#29) Curved Washers 4x (#33) Flat Washers
6x (#31) M8 * 16 Hex Bolt 4x (# 32) Spring Washer
4x (#11) M6 * 12 Hex Screws 2x (#49) M5 * 10 Cross Head Screw
Required Parts:
(#39) Console Mast (#93) Bottle Holder
(#10) Heart Rate Handle Bars (#19) Console
Attaching the Mast
A.) Locate the ends of the included cable that should be sticking out of the top and bottom
of the (#39) Console Mast, labeled (#37) as seen in Step 4 Figure.
B.) Orient the bottom end of (#39) Console Mast near the top of the opening of the Main
Frame.
C.) Connect cable end of (#37) to the input connector (#83) that is inside the frame, as seen
in Step 4 Figure.
D.) Slide Console Mast (#39) onto the Main Frame.
NOTE: Make sure not to pinch the cable assembly when attaching the console
onto the mounting bracket.
E.) Secure both assemblies by using:
2x (#29) Curved Washers 4x (#33) Flat Washers
6x (#31) M8 * 16 Hex Bolt 4x (# 32) Spring Washer
As seen in Step 4 Figure
Note: (# 32) Spring Washer is only used on the flat sides of the mast,
(#29) Curved Washer in only used on the curved front of the mast.
Attaching the Bottle Holder
F.) Locate the two threaded holes along the inside of the mast
G.) Attach (#93) Bottle Holder onto the mast using:
2x (#49) M5 * 10 Cross Head Screw
H.) Slide (#9) Water Bottle into the water bottle holder.
To Next Page
Loading...
