CHAPTER 1 OPERATION GUIDE
32
-- Do not apply strong detergent to clean the unit
-- Do not touch the screen with sharp-headed objects
-- Charge the unit in time when the battery level is low
-- Before using “RESET” or repairing, please keep a copy of all important
data so as to re-input them later
-- Pay attention to lifespan of the battery
-- Operate the unit properly with carefulness to avoid damaging the
unit
-- Charge the unit for 4-6 hours for the rst time
-- Damages caused by plugging the external card improperly are not
natural else, consumer must afford the relevant expenses similarly
-- Do not use adhesive and avoid damaging the unit
-- You’d better have the concept that damages will take place easily if
the electronic product is affected with damp
-- Show your warranty card together with the original ofcial invoice if
you want repair your unit in our Customer Service Center
System Initialization
If the unit malfunctions, press and the message “System les are
recognizing, please wait...” will appear, after a moment, “Initializing Sys-
tem? Y / N” will appear on the screen. Press to cancel initializing,
press to reset the system, the screen will show a message “The
data may be deleted while initializing system! Continue? Y / N”. Press
to keep it, press to delete the data, an alert message “User’s
data will be deleted! Initialize System! Continue? Y / N” will be displayed
on the screen. Press to keep the data. If you press , the data
will be deleted and a message “If the user’s data is deleted, you need
to download data again! Saving data? Y / N” will appear; press
to delete the data, press to keep it. After the system is reset and
data is deleted, the system will prompt you to set the calibration. Once
calibration is OK, “The time and other settings may have been changed.
Reset them if necessary.” will appear on the screen. Touch “Enter” or
press to enter the main menu screen.
To Next Page