10 | support@instantappliances.com | 1-800-828-7280
Get started
Initial test run
Do you have to do the test run? No — but getting to know the ins and outs of your
Omni Pro prepares you for success in the kitchen! Take a few minutes to get to know how
this hot number works.
Stage 1: Setting up for cooking
01 Open the oven door.
Slide the cooking pan onto the
bottom rack position, and into the
cooking chamber.
Close the door.
02 Plug the power cord into a 120 V
power source.
The oven is in standby mode and the
display shows OFF.
03 Touch Air Fry.
Leave the temperature at 400 °F.
04 Touch the time field to select the
cooking time.
05 Use the + / – keys to adjust the
cooking time to 20 minutes (00:20).
06 Touch Start to begin.
The display shows On and the status bar
shows Preheating.
Stage 2: “Cooking” (…but not really, this
is just a test!)
01 When the oven reaches the perfect
temperature, it beeps and begins the
cooking countdown.
Do not add food during the initial
test run.
02 Partway through cooking, the display
shows turn Food.
Wait 10 seconds for the program to
resume automatically, or, open and
close the oven door to pause and
resume the program manually.
When the oven door is open, the
display shows OPEN.
03 The oven counts down the last minute
of the cooking time in seconds and
beeps when nished.
The oven will enter the Keep Warm
state and once the program nishes,
the display shows End.
04 Touch Cancel to return to standby
mode and start cooking for real!
If you forget this last step, the toaster
oven will beep to remind you about it.
CAUTION
Metal, glass surfaces and accessories will be hot during and after cooking. To
avoid burn injury, do not touch the appliance, or attempt to insert or remove
accessories without proper hand protection.
To Next Page
Loading...
Need help?
General
