44
User Manual
Install the steam release assembly
Place the steam release valve on the steam release pipe and press
down firmly. Insert the tabs on the steam release cover into the holes
on the lid and press down on the opposite side until the cover is seated.
When installed properly, the steam release assembly is firmly attached to the lid. It
should remain in place when the lid is turned over.
Setting up the condensation collector
The condensation collector sits at the back of the multi-cooker base
and accumulates overflow moisture from the condensation rim. It
should be installed before cooking, then emptied and rinsed out after
each use.
Install the condensation collector
Align the grooves on the condensation collector with the tabs on the
back of the multi-cooker base and slide the condensation collector
into place.
Remove the condensation collector
Pull the condensation collector away from the multi-cooker base; do
not pull down.
Note the tabs on the multi-cooker base and the grooves on the condensation
collector.
To Next Page
Loading...
