Instant POT PRO PLUS - Cooking Pot and Base Cleaning

45
User Manual
CLEANING
Clean your Instant Pot Pro Plus after each use. Always unplug the unit
and let all parts cool to room temperature before cleaning. Before use or
storing, make sure all surfaces are dry.
Part Cleaning instructions
Accessories
• Steam Rack
• Wash after each use
• Hand wash with hot water and mild dish soap or wash
in dishwasher, top rack
• Never use harsh chemical detergents, powders or
scouring pads on accessories
Lid and Parts
• Anti-Block Shield
• Sealing Ring
• Steam Release Valve
• Steam release cover
• Condensation Collector
• Hand wash with hot water and mild dish soap
• Remove all small parts from lid before washing
• With steam release valve and anti-block shield
removed, clean interior of steam release pipe to
prevent clogging
• After cleaning, store the lid upside down on the
multi-cooker base
• Store sealing rings in a well-ventilated area to
disperse odor
• To eliminate odors from sealing ring, add 1 cup
(8 oz / 250 mL) water and 1 cup (8 oz / 250 mL)
white vinegar to cooking pot, and run Pressure Cook
for 5–10 minutes, then use Quick Steam Release
• Empty and rinse condensation collector after each use
Cooking Pot • Wash after each use
• Hand wash with hot water and mild dish soap or wash
in dishwasher*
• Hard water stains may need a vinegar-dampened
sponge and scrubbing to remove
• For tough or burned food residue, soak in hot water
for a few hours before cleaning
• Dry all exterior surfaces before placing in multi-cooker
base
Power cord • Use a barely-damp cloth to wipe any particles off cord
Cooker base • Wipe the inside of the multi-cooker base as well as the
condensation rim with a barely-damp cloth, and allow
to air dry
• Clean the outside of the multi-cooker base and the
control panel with a soft, barely-damp cloth or sponge
*Some discoloration may occur after machine washing, but this will not affect the
multi-cooker’s safety or performance.