This option is similar to Option 3001-P but with a single alarm only. See page 7 for connection details. Wire for AL1 only.
This option is similar to Option 3001-M but with a one alarm set point only. See diagram “M” on page 20 for connections. Wire for AL1
only.
See page 7 for connection details.
See page 7 for connection details. Wire for AL1 & AL2 only.
If fitted, this option will accurately linearise signals for flow applications (square root extraction), s-curve (cylinder applications) and
other non-linear signals. The type of linearisation required is specified at time of order and cannot be user selectable. However, the
user has the option of toggling the lineariser feature 'ON' or 'OFF' in the process ('PRo') menu. See page 9 for programming details.
See page 7 for connection details. Select DIGIbus or ASCIIbus protocol from the program menu. See additional protocol documents.
One Set Point (Electro-Mechanical Relay)Option 3004-M
One Set Point (Solid-State Relay)Option 3004-P
0 - 20mA / 4 - 20mA / 0 - 10V Analogue Output OptionOption 3003
RS485 Serial Interface OptionOption 3002
Two Set Point (Electro-Mechanical Relays)Option 3001-M
Two Set Point (Solid-State Relays)Option 3001-P
Lineariser (Square Root / Cylinder / Sphere etc)Option 3000
This option provides two alarm set points with electro-mechanical relays. This option board slots into the upper slot of the panel meter
box. The upper terminals are clearly numbered 13-28 to differentiate them from the lower terminals. Both normally open and normally
closed contacts are provides with each relay. The relays are rated at 250VAC / 30VDC @ 2A. Visual LED alarm indication is provided
on the panel meter front. For connection wiring details, see diagram “M” on page 20. Connect wires for AL1 & AL2 only.
Page 15
To Next Page
Loading...