Integra DHC-9.9

55
First Time Setup—Continued
To use bi-amping, you must change the “Speaker Type”
setting. For hookup information, see page 25.
Notes:
• When bi-amping is used, the AV controller is able to
drive up to 5.1 speakers in the main room.
• Before you change these settings, turn down the vol-
ume.
Note:
This procedure can also be performed on the AV control-
ler by using its [Setup] button, arrow buttons, and [Enter]
button.
Speaker Settings
The onscreen menus shown in this manual may be
slightly different from what you see on your TV.
1
Press the [Receiver] button, fol-
lowed by the [Setup] button.
The main menu appears onscreen.
If the main menu doesn’t appear, make
sure the appropriate external input is
selected on your TV.
2
Use the Up and Down [q]/[w] but-
tons to select “2. Speaker
Setup”, and then press [Enter].
The “Speaker Setup” menu appears.
-
TV VOL
--
/
---
10 11 12
D.TUN
+10
0
Clear
456
789
Input Selector
Tape
Tuner
CD
Phono
Macro
123
VCRDVD
CDR/MD
CD
Zone 2
Remote Mode
Dimmer
Tape/AMP
Sleep
Receiver TV
Dock
Cable
VOL
CH
Disc
Album
+
-
Enter
T
o
p
M
e
n
u
M
e
n
u
Display Muting
E
x
i
t
G
u
i
d
e
Prev
CH
R
e
t
u
r
n
S
e
t
u
p
Playlist
RandomRec
SAT
Zone 3
2, 3
1
1, 5
2–
4
If you change these settings, you must run the auto-
matic speaker setup again (see page 58).
Receiver
S
e
t
u
p
Enter
Enter
2. Speaker Setup
1. Speaker Settings
2. Speaker Config
3. Speaker Distance
4. Level Calibration
5. Equalizer Settings
6. THX Audio Setup
3
Use the Up and Down [q]/[w] but-
tons to select “1. Speaker Set-
tings”, and then press [Enter].
The “Speaker Settings” menu appears.
4
Use the Up and Down [q]/[w] but-
tons to select “Speaker Type”,
and use the Left and Right
[e]/[r] buttons to select:
Normal:
Select this if you’ve connected your
front speakers normally.
Bi-Amp:
Select this if you’ve connected your
front speakers for bi-amped opera-
tion.
5
Press the [Setup] button.
Setup closes.
Enter
Enter
2–1. Speaker Settings
Speaker Type Front Normal
MOVE VALUE RETURN
RETURN
EXIT
SETUP
Enter
S
e
t
u
p