Integra DOSE IT - Parameter Settings

DOSE IT – Operating instructions V08 Operation
www.integra-biosciences.com 13
4.2 Parameter settings
4.2.1 System parameters
4.2.2 Program parameters
Some parameters described are not displayed in every program mode.
System-Parameter Description
Language Set the desired language.
Time/Date Set time and date.
Display contrast Change the contrast of the display.
Access code Provides user access restrictions to parameters.
Info General information on the unit:
• Version of the software
• Version of the electronics
• Serial number.
Parameter Description Range Default
Name Allows to name the program with up to 16
alphanumeric symbols. Press the arrow keys
simultaneously to delete the program name.
--
Type Defines the program mode: “P
UMP” for continu-
ous pumping of a liquid, “D
ISPENSE” for the
dosing of liquids, or “C
USTOMIZE” to create a
customized application.
Dispense
Pump
Customize
Dispense
Tubing-ID
(mm)
Defines the Inner Diameter (ID) of the tubing. 1.0 – 8.0 mm 4.0 m m
Flow rate
(ml/min)
Allows to set the pump speed. The flow rate
depends on the tubing inner diameter.
Time
(h min s)
Defines the duration of the pumping. Entering
0 h 0 min 0 s puts the unit in continuous opera-
tion, which is represented by the infinite symbol
(.
1'' – 9 h 59' 59''

1h
Volume Defines the volume of a dose in the dispensing
mode.
0.01 – 9999 ml 10 ml
Repetitions Defines the number of doses in the dispensing
mode. Entering 0 results in an unlimited num-
ber of doses, which is represented by the
infinite symbol (.
1 – 999

20