17
> Specifications > Advanced Setup > Listening Modes
> Network Functions > Basic Manual
|Troubleshooting Supplementary Information, etc.
Setting Item Default Value Setting Details
Surround 0.0 dB After selecting the speaker frequency from
between "25 Hz" and "16 kHz" with the cursors
/
, adjust the volume of that frequency between
"−6.0 dB" and "＋6.0 dB" with / .
Surround Back 0.0 dB After selecting the speaker frequency from
between "25 Hz" and "16 kHz" with the cursors
/
, adjust the volume of that frequency between
"−6.0 dB" and "＋6.0 dB" with / .
•
Depending on the use of the ZONE speakers, it
may not be possible to select this setting.
Subwoofer 0.0 dB After selecting the speaker frequency from
between "25 Hz" and "160 Hz" with the cursors
/
, adjust the volume of that frequency between
"−6.0 dB" and "＋6.0 dB" with / .
•
This cannot be selected if "No" is set in
"Configuration" - "Subwoofer".
•
The result may not be as expected depending on the input source and listening mode setting.
■ 7. THX Audio
Setting item Default Value Setting Details
Back Speaker
Spacing
>4.0 ft/>1.2 m Select the distance between the surround back
speakers from "<1.0 ft/<0.3 m", "1.0 - 4.0 ft/0.3
- 1.2 m", and ">4.0 ft/>1.2 m".
•
The unit of distance (feet / meters) shown is
the unit selected for use in "Distance".
•
Depending on the use of the ZONE
speakers, it may not be possible to select
this setting.
•
If an item cannot be selected even though
connection is correct, check that the settings
in "Configuration" - "Speaker Channels"
matches the number of connected channels.
Setting item Default Value Setting Details
THX Ultra /
Select Subwoofer
No Set "Yes" or "No" of the connection of the THX
certified subwoofer.
"Yes": When a THX-certified subwoofer is
connected
"No": When a THX-certified subwoofer is not
connected
•
The setting cannot be changed if
"Configuration" - "Subwoofer" is set to "No".
BGC Off If your listening room layout (for practical or
aesthetic reasons) locates most of the listeners
close to the rear wall, the resulting bass level
can be sufficiently reinforced by the boundary
that the overall sound becomes "boomy". THX
Select receivers contain a Boundary Gain
Compensation (BGC) feature to improve bass
balance.
"On": When this function is to be used
"Off": When this function is not to be used
•
In the following cases, the setting cannot be
changed:
–
"Configuration" - "Subwoofer" is set to
"No".
–
"THX Ultra / Select Subwoofer" is set to
"No".
To Next Page
Loading...
Need help?
General
