18
> Specifications > Advanced Setup > Listening Modes
> Network Functions > Basic Manual
|Troubleshooting Supplementary Information, etc.
Setting item Default Value Setting Details
Loudness Plus On When the setting is set to "On", it is possible to
enjoy even subtle nuances of audio expression
at low volume. This is only available when the
THX listening mode is selected.
THX Loudness Plus
THX Loudness Plus is a new volume control
technology featured in THX Ultra and THX
Select Certified receivers.
With THX Loudness Plus, home theater
audiences can now experience the rich details
in a surround mix at any volume level.
A consequence of turning the volume below
Reference Level is that certain sound elements
can be lost or perceived differently by the
listener. THX Loudness Plus compensates for
the tonal and spatial shifts that occur when the
volume is reduced by intelligently adjusting
ambient surround channel levels and frequency
response. This enables users experience
the true impact of soundtracks regardless of
the volume setting. THX Loudness Plus is
automatically applied when listening in any THX
listening mode. The new THX Cinema, THX
Music, and THX Games modes are tailored to
apply the proper THX Loudness Plus settings
for each type of content.
■ 8. EQ for Standing Wave
This controls the affect of the standing waves that occur when sound waves reverberating
off obstacles such as walls interfere with the original sound waves.
Setting Item Default Value Setting Details
Filter 1-3 0.0 dB 1. After selecting the Filter to adjust from "Filter 1"
to "Filter 3" with
/
, press Enter.
2. Select the frequency with
/
, then adjust
the attenuation with
/
. The frequency can
be selected between "63 Hz" and "250 Hz".
Attenuation can be selected between "0.0 dB"
and "12.0 dB" (0.5 dB intervals).
3. Audio Adjust
Make advanced settings such as those related to multiplex audio, settings for the LFE level,
or those related to the volume of this unit.
■ 1. Multiplex/Mono
Setting Item Default Value Setting Details
Multiplex Input
Channel
Main Set the audio channel or language to be output
when playing multiplex audio or multilingual TV
broadcasts etc.
"Main": Main channel only
"Sub": Sub channel only
"Main/Sub": Main and sub channels will be output
at the same time.
•
If multiplex audio is being played, "1＋1" will be
displayed when
on the remote controller is
pressed.
Mono Input
Channel
Left + Right Set the input channel to use for playing any 2 ch
digital source such as Dolby Digital, or 2 ch analog/
PCM source in the Mono listening mode.
"Left": Left channel only
"Right": Right channel only
"Left + Right" : Left and right channels
Mono Output
Speaker
Center Select the speaker to output monaural audio in the
Mono listening mode.
"Center": Audio is output from the center speaker.
"Left/Right": Audio is output from the front L/R
speakers.
•
If an item cannot be selected even though
connection is correct, check that the settings
in "2. Speaker" - "Configuration" - "Speaker
Channels" matches the number of connected
channels.
To Next Page
Loading...
Need help?
General
