26
> Specifications > Advanced Setup > Listening Modes
> Network Functions > Basic Manual
|Troubleshooting Supplementary Information, etc.
Setting Item Default Value Setting Details
Network Standby On When this feature is turned "On", you can turn
on the power of the unit via the network using
an application such as Integra Remote that can
control this unit.
•
When "Network Standby" is used, the power
consumption increases even when the unit
is on standby. However, the increase in
power consumption is kept to a minimum by
automatically entering the Hybrid Standby
mode, where only the essential circuit is
operating.
•
When the connection to the network is lost,
"Network Standby" is disabled to reduce power
consumption. Use the power button on the
remote controller or main unit to turn the unit on
if this happens.
•
Wait for a while if "Network Standby" cannot be selected. It will appear when the network feature is
started.
■ 4. 12V Trigger A
Set when outputting the control signal (maximum 12 V/100 mA) through the 12V TRIGGER
OUT A jack. Different settings can be set for each input selector. You can enable power link
operation when you connect the unit and the external devices equipped with 12V trigger
input jack.
Setting Item Default Value Setting Details
Delay 0 sec Set after how many seconds the 12V trigger output
will occur in response to the unit's operation. As
some devices cause a large current when they turn
on, delay the output if such devices are connected.
Select a value between "0 sec" to "3 sec".
Setting Item Default Value Setting Details
BD/DVD Main
Set the 12V trigger output setting to each input.
"Off": No output
"Main": Output when "BD/DVD" is selected as
input
for main room.
"Zone 2": Output when "BD/DVD" is selected as
input
for ZONE2.
"Main/Zone 2": Output when "BD/DVD" is selected
as input for main room or ZONE2.
"
Zone 3
"
: Output when
"
BD/DVD
"
is selected as
input
for ZONE3.
"
Main/Zone 3
"
: Output when
"
BD/DVD
"
is selected
as input for main room or ZONE3.
"
Zone 2/Zone 3
"
: Output when
"
BD/DVD
"
is
selected as input for ZONE2 or ZONE3.
"
Main/Zone 2/Zone 3
"
: Output when
"
BD/DVD
"
is selected as input for main room, ZONE2 or
ZONE3.
CBL/SAT Main
Set the 12V trigger output setting to each input.
"Off": No output
"Main": Output when "
CBL/SAT
" is selected as
input for
main room.
"Zone 2": Output when "
CBL/SAT
" is selected as
input for ZONE2.
"Main/Zone 2": Output when "
CBL/SAT
" is selected
as input for main room or ZONE2
.
"
Zone 3
"
: Output when
"CBL/SAT"
is selected as
input
for ZONE3.
"
Main/Zone 3
"
: Output when
"CBL/SAT"
is selected
as input for main room or ZONE3.
"
Zone 2/Zone 3
"
: Output when
"CBL/SAT"
is
selected as input for ZONE2 or ZONE3.
"
Main/Zone 2/Zone 3
"
: Output when
"CBL/SAT"
is selected as input for main room, ZONE2 or
ZONE3.
To Next Page
Loading...
Need help?
General
