Connect an Enrollee to a WiFi Network or Access Point
Perform these steps to connect an enrollee to the network you just created. This assumes that the registrar
computer is running the WiFi connection utility.
NOTE: To achieve transfer rates greater than 54 Mbps on 802.11n connections, WPA2-AES security must be
selected. No security (None) can be selected to enable network setup and troubleshooting.
1. At the enrollee you want to connect the network, a message tells you that one or more access points with
Wi-Fi Protected Setup capability is within range of your wireless computer. Click on this message. (Or, you
can select the network from the WiFi Networks list in the WiFi connection utility main window.)
2. The WiFi Protected Setup Wizard start up page opens. Use the Available Networks list to select the
network that you want to connect to (in this example it is MyWPS). Then click Next.
3. The Discovery window opens. The enrollee that you want to connect to the network discovers the registrar
for the network. Assuming that the Discovery process succeeds, the name of the registrar or access point is
displayed.
Intel® PROSet/Wireless WiFi Connection Utility User's Guide
To Next Page
Loading...
Need help?
General
