sure the power LED on the front of the access point or router is green.
I cannot connect to any wireless
network.
Radio may be disabled. See: Turn on/Turn off Radio
for more information.
Intel® PROSet/Wireless WiFi
software asks me for a key when
I try to connect to a wireless
network.
Network has security enabled. See Security Overview
for more information.
No WiFi networks are displayed
in the list of available networks.
Computer is too far from wireless network or there are no WiFi networks in the
area.
How do I configure roaming
identity for multiple users?
Configure Roaming Identity to support multiple users:
If you use a Pre-logon/Common
profile that requires the roaming identity to be
based on the Windows logon credentials, the creator of the profile can add a
roaming identity that uses %username% and %domain%. The roaming
identity is parsed and the appropriate log on information is substituted for the
keywords. This allows maximum flexibility in configuring the roaming identity
while allowing multiple users to share the profile.
Please see your authentication server user guide for directions about how to
format a suitable roaming identity. Possible formats are:
%domain%\%username%
%username%@%domain%
%username%@%domain%.com
%username%@mynetwork.com
If Roaming Identity is cleared, %domain%\%username% is the default.
NOTE: Credentials: This user name and domain must match the user name
that is set in the authentication server by the administrator prior to client
authentication. The user name is case-sensitive. This name specifies the
identity supplied to the authenticator by the authentication protocol operating
over the TLS tunnel. This user identity is securely transmitted to the server
only after an encrypted channel has been verified and established.
Back to Top
Back to Contents
Trademarks and Disclaimers
Intel® PROSet/Wireless WiFi Connection Utility User's Guide
To Next Page
Loading...
