Hide device to device application settings
To remove the Device to Device (ad hoc) operating mode from the Create WiFi Profile General
Settings, select both Disable device to device networking and Hide device to device
application settings. This prevents a user from creating profiles that support Device to Device
(ad hoc) network.
NOTE: This setting is only applicable for packages running on Windows* XP Client.
Driver Event
Logging
Driver event logging captures and logs events that are specific to the driver. These events can
be viewed on the Wireless Event Viewer. Here you can select to enable standard logging or
troubleshooting logging. See Wireless Event Viewer Settings
Enable Driver Event Logging
Standard Logging
Troubleshooting Logging
Import and
Export
Enable profiles to be imported and exported
Select to allow profiles to be imported from or exported to a user's computer. If enabled here,
then profiles that are placed in the auto import folder will be imported automatically.
Intel® Active
Management
Technology
Settings
Username
Password
Enter the Username and Password to override the default names used by Intel® Active
Management Technology to synchronize Intel® PROSet/Wireless WiFi Connection Utility profiles.
Intel® My
WiFi
Technology
(MWT)
Enable Intel® MWT Cell Forwarding API.
Click to enable a third-party application to use Intel® MWT Cell Forwarding of IP Packet API for
the purpose of bridging an Intel® MWT network that uses a BSS connection.
NOTE: This setting is not applicable for Windows* XP Client. This setting is also not applicable
for a client equipped with one of the following adapters:
Intel® PRO/Wireless 3945ABG Network Connection
Intel® Wireless WiFi Link 4965AGN
Intel® Wireless WiFi Link 4965AG_
Maintain
Connection
Hide the Maintain Connection setting for user profiles
Select to hide the Maintain Connection option in the Create WiFi Profile Advanced Settings
. This
Maintain Connection option maintains the WiFi connection with a user profile after log off.
NOTE: The Maintain Connection option may be used with Nortel VPN client when it is configured
to Logoff on Connect.
NOTE: This setting is only applicable for packages running on Windows* XP Client.
Maintain
Smart Card
Connection
Maintain connection if smart card is unavailable
Select to maintain the connection if the smart card is removed while the wireless device is
connected to a network that uses smart card credentials. The default behavior for the WiFi
connection utility is to close the connection that uses smart card credentials if the smart card is
removed. Turning this feature On will cause the connection to remain connected (unless re-
authentication is required for another reason). Select to maintain a connection if the smart card
is removed while the computer is connected to a network using smart card/SIM credentials.
NOTE: This setting is only applicable for packages running on Windows* XP Client.
Message On
Radio Toggle
Enable WiFi On Toggle Message on a user's computer
Select to enables a third-party application to notify a user that the Intel® PROSet/Wireless WiFi
Connection Utility WiFi On / Off switch is disabled.
Intel® PROSet/Wireless WiFi Connection Utility User's Guide
To Next Page
Loading...
Need help?
General
